Auto Sentry® flex User Manual 104 Service Unit Screen
Version information may include but is not limited to the following application names:
CAGE.exe. Credit card clearing software.
CoreGatewayServer.exe. Sever application.
Touch.exe. WashConnect® touch-screen software.
Deviceint.exe. Device interface software.
Bill Acceptor. Configured bill acceptor for the WashConnect®.
Bill Dispenser Diagnostics and Life History
Sensor Health, Pot Level (potentiometer) and Legend are displayed for Fujitsu™ brand bill
dispensers. Pot Level shows the MDS sensor health.
Life History is displayed for both Fujitsu and De La Rue™ brand bill dispensers. Life history shows
errors and more on the board until it is reset.
Exiting the Service Unit Screen
Once all maintenance has been completed in the main Service Unit Screen or Diagnostics Screen,
tap the Exit button.
Figure 75. Exit Button on Service Unit Screen
Reset Alarm
If the alarm deterrent device input is continuous (not momentary) or there is a need to deactivate
the alarm outputs, we will allow the employee to enter the Service Unit Screen by logging in with
the proper credentials and allow them to access the Diagnostics screen. From the Diagnostics
screen, there will be two buttons at the center bottom of the screen labeled Reset Alarm and Dis-
able Alarm. When the outputs are still active, the employee may turn them off by selecting the
Reset Alarm button. If they need to do some maintenance while in the unit they may select the
Disable Alarm button to prevent the alarm from inadvertently going off. When the Disable Alarm
button is selected, the button reappears as Enable Alarm. Selecting the Enable Alarm button reac-
tivates the alarm to be ready to monitor warnings again. If the employee forgets to enable the
alarm, leaving the Service Unit screen will automatically enable the alarm for you.
1 Open the Auto Sentry, and log in to the Service Unit - Diagnostics screen.
Two buttons appear at the center bottom of the screen labeled Reset Alarm and Disable Alarm.
2 When the outputs are still active, the employee may turn them off by selecting the Reset
Alarm button.
To Next Page
Loading...
General