ICS Auto Sentry flex - Add Bills (to the Auto Sentry)

Auto Sentry® flex User Manual 98 Service Unit Screen
▪ Enter total amount (in dollars) you are adding to Hopper 1. Tap the ENTER button when
finished.
3 Type the dollar amount on the keypad.
The amount appears in the keypad display.
4 Tap Enter.
The dollar amount is confirmed in the verification box.
▪ (Optional) If the amount is incorrect, tap Cancel to start over.
5 Tap Enter to confirm. The amount is added and the instruction box confirms the transaction.
The quantity is displayed on the coin hopper icon.
6 Take the receipt.
7 Slide out the coin hopper drawer. Physically add coins, and then slide the drawer back.
Add Bills (to the Auto Sentry)
Do this when you need to replenish the bills in an Auto Sentry® flex® bill dispenser.
NOTE: Bill dispenser capacities:
▪ Fujitsu
®
— 3 cassettes: 2,000 | 2,000 |2,000 used bills.
▪ Talaris
®
— 2 cassettes: 1,800 | 1,800 used bills.
▪ Multi-mech
®
— 2 cassettes: 600 | 1,300 used bills.
▪ Gen Mega
®
— 2 cassettes: 2000 | 2000 new bills
1 On the Service Unit Screen, press a bill dispenser icon.
2 Tap Add, and then tap Start. The instruction box displays the following message:
▪ Enter the total amount (in dollars) you are adding to Dispenser 1 (2 or 3). Tap the ENTER
button when finished.
3 Enter the amount on the keypad.
The amount appears in the keypad display.
4 Tap Enter. The amount is confirmed in the verification box.
▪ (Optional) If the amount is incorrect, tap Cancel to start over.