Model 250
Printer Applicator
Operators/Technical Manual Section Six
Section 6 Page 13 of 20
SYMPTOM DIAGNOSIS SOLUTION
Waste take up runs
continuously.
Incorrect mode setting in print
engine.
Correct.
Label liner not
rewinding correctly.
Rewind reel slip clutch
malfunctioning or broken
drive belt.
Request qualified service
assistance.
Printer will not print 1. Printer not on-line.
2. On-line lamp on applicator
not lit.
3. Label fault lamp is lit.
4. Ribbon fault lamp is lit.
5. Print head cable are
disconnected or damaged.
6. Data not received from
input device.
Press Line button on
printer.
Press Job/Reset button.
Check label threading and
make sure label hold
down is close.
Check that ribbon is
threading through ribbon
sensor.
Inspect and correct.
Check input device and
connecting cable.
Retransmit data.
Quantity is present
in queue but will not
print
1. Faulty interfaces cable or
loose connection.
2. Faulty interface card or
loose connection.
3. External signal driver on
main PCB is faulty
Inspect, correct, or replace
cable.
Inspect, correct, or replace
PCB.
Replace PCB.
Light printing or no
printing on the left
or right side of the
label.
Printhead pressure needs
adjustment or printhead out of
alignment.
See “Printhead Pressure”
adjustment in Sato manual
To Next Page
Loading...
