Model 250
Printer Applicator
Operators/Technical Manual Section Three
Section 3 Page 16 of 19
APPLICATOR SETUP
Has label/web path been adjusted? YES NO
Has vacuum system been adjusted? YES NO
Has tamp pad height been adjusted for proper label
feed?
YES NO
Check to make sure that the tamp assemblies are not
binding
YES NO
Check tamp assembly fasteners to see that they are
tight and have Loc-tite on them.
YES NO
Has applicator height been adjusted so that all products
can pass under the applicator?
YES NO
Is tamp pad hitting product flatly? YES NO
Has smart tamp been adjusted? YES NO
Is product detector correctly positioned & working? YES NO
Has product delay been adjusted for all product sizes? YES NO
Are leveling feet being used? YES NO
Is Beacon/Audible Alarm working (Check all conditions) YES NO
Has low label sensor been adjusted? YES NO
To Next Page
Loading...
