IEI Technology AFL-xxx-9103 User Manual

AFL-xxx-9103 Panel PC
Page 88

UDMA1
Ultra DMA mode 0 selected with a maximum data
transfer rate of 16.6 MB/s

UDMA1
Ultra DMA mode 1 selected with a maximum data
transfer rate of 25 MB/s

UDMA2
Ultra DMA mode 2 selected with a maximum data
transfer rate of 33.3 MB/s

UDMA3
Ultra DMA mode 3 selected with a maximum data
transfer rate of 44 MB/s (To use this mode, it is required
that an 80-conductor ATA cable is used.)

UDMA4
Ultra DMA mode 4 selected with a maximum data
transfer rate of 66.6 MB/s (To use this mode, it is
required that an 80-conductor ATA cable is used.)

UDMA5
Ultra DMA mode 5 selected with a maximum data
transfer rate of 99.9 MB/s (To use this mode, it is
required that an 80-conductor ATA cable is used.)
 S.M.A.R.T [Auto]
Use the S.M.A.R.T option to auto-detect, disable or enable Self-Monitoring Analysis and
Reporting Technology (SMART) on the drive on the specified channel. S.M.A.R.T predicts
impending drive failures. The S.M.A.R.T BIOS option enables or disables this function.

Auto DEFAULT
BIOS auto detects HDD SMART support.

Disabled
Prevents BIOS from using the HDD SMART feature.

Enabled
Allows BIOS to use the HDD SMART feature
 32Bit Data Transfer [Enabled]
Use the 32Bit Data Transfer BIOS option to enables or disable 32-bit data transfers.

Disabled
Prevents the BIOS from using 32-bit data transfers.

Enabled DEFAULT
Allows BIOS to use 32-bit data transfers on supported
hard disk drives.

IEI Technology AFL-xxx-9103 Specifications

General

Brand	IEI Technology
Model	AFL-xxx-9103
Category	Touch Panel
Language	English