Intel FALCON 8+

NORMAL PROCEDURES
© 2017 Intel Corporation. All rights reserved. 41
REV 00
APR 2017
4.5.2 Initial Preflight
Aircraft Condition Inspect
Perform a visual inspection of the aircraft. Inspect for:
Central Unit/ Top Canopy No Cracks, Dents, Tears
Propeller attach fittings Fasteners, Hand-tight
Propeller Surfaces Clean; No Cracks, Dents,
Tears
SD Card / USB Stick Present
Camera / Payload Installed
Camera/Payload Lens Cap Removed
Camera Battery Pack (if required) Charged, Connected
Camera / Payload Power On
Propulsion Intel
®
Powerpack™ Battery Charged, Connected
Prior to each mission, charge each Intel
®
Powerpack™ Battery to 100%. Replace battery if
remaining charge is inadequate for planned flight time. Secure battery in aircraft in proper
location with Intel label facing upward.
Intel
®
Falcon™ 8+ UAS Power Switch Press and Hold
Intel
®
Cockpit GCS Antenna Panel Inspect; Fully Extended
Intel
®
Cockpit GCS Harness Installed
Intel
®
Cockpit GCS Battery Level Charged, Connected
Prior to each mission, charge each Intel
®
Powerpack™ Battery to 100%. Replace battery if
remaining charge is inadequate for planned mission time plus 30 minutes. Secure battery in
proper location with Intel label facing downward.
Intel
®
Cockpit GCS Press and Hold
Intel
®
Cockpit GCS Touchscreen Tablet On
Landing Gear Inspect
Flight Area Clear
Propeller Area Clear
Communications Link Established
Warning:
Violation of these safety precautions in the Pre-flight Check
List will result in the loss of the limited warranty included in
the Terms and Conditions of Sale for this product!