Chapter 13: Alarm and event setup
TruVision NVR 11 User Manual 109
• Object Removed: A camera has detected that an object has been removed from a
designated region, such as exhibits on display.
• R/W HDD is 95% full: The R/W HDD is nearly full.
• All HDDs are full.
• Panel Heartbeat Alarm: This is an OH event. There is no communication between
the intrusion panel and the recorder.
• Arming Panel Event: This is an intrusion integration event. The intrusion panel has
been armed.
• Disarming Panel Event: This is an intrusion integration event. The intrusion panel
has been disarmed.
• Intrusion Alarm: This is an intrusion integration event. An intrusion alarm has been
triggered by the intrusion panel.
To set up event notifications:
1. From the menu toolbar, click Alarm & Event Setup > Notifications.
2. Check Display Event Icon so that the event icon appears in the OSD in live view
when an alarm or event is triggered (default is enabled).
3. Under Event Hint Settings, click the Actions button. From the drop-down list, select
the desired event notifications to be listed in the alarm center in live view and click
OK. See “Event notification” on page 107 for the complete list.
4. Select the event priority: VCA < Motion or VCA > Motion. Default is VCA < Motion,
where motion has priority over VCA.
5. Select a technical event notification and how the recorder should respond to it.
Under Notification Type, select the desired technical event notification:
• HDD Full: All installed HDDs are full and will not record any more video.
• HDD Error: Errors occurred while files were being written to the HDD, there is no
HDD installed, or the HDD had failed to initialize.
• Network Disconnected: Disconnected network cable.
• Duplicate IP Address Found: There is an IP address conflict with another
system on the network.
• Illegal Login: Wrong user ID or password used.
• Abnormal Record: HDD cannot record any more files. This could be due to the
overwrite option being disabled so recorded files are locked and cannot be
deleted.
Select one or more response method: Enable Alarm Audio, Notify Alarm Host, Send
Email, and Trigger Alarm Output.
Note: The list of response methods available depends on the notification type
selected.
6. Repeat step 5 for other notification types.
To Next Page
Loading...
Need help?
General
