Interlogix TruVision series - Pppoe Settings

Chapter 11: Network settings
90 TruVision NVR 11 User Manual
Option Description
10.
Multicast IP
Enter a D-class IP address between 224.0.0.0 to 239.255.255.255. Only
specify this option if you are using the multicast function. Some routers
prohibit the use of multicast function in case of a network storm.
11.
IPv6 Address 1
Enter the IPv6 address for the recorder. This is the IP address of the local
network to which the recorder is connected.
Default value is fe80:240:3dff:fe7e:926f/64
12.
IPv6 Address 2
When the recorder is connected to an external network (such as the
internet), the second IPv6 address is automatically assigned.
13.
IPv6 Default
Gateway
Enter the IPv6 address of your network gateway so the recorder will be
recognized within the network. This is typically the IP address of your
router.
14.
MTU (bytes)
Enter a value between 500 and 9676. Default is 1500.
15.
Alternate DNS
Server
Enter the alternate domain name server to use with the recorder. It must
match the DNS server information of your router. Check your router’s
browser interface or contact your ISP for the information.
16.
HTTP Port
Use the HTTP port for remote internet browser access.
Enter the HTTP port value, which can be any port number that is not
occupied. The default value is 80.
17.
RTSP Service
Port
The RTSP (Real Time Streaming Protocol) is a network control protocol
designed for use in entertainment and communications systems to control
streaming media servers.
Enter the RTSP port value, which can be between1 to 65535. The default
value is 554.
18.
Outgoing
Bandwidth Limit
(Kbps)
The total outgoing bandwidth limit is a threshold you can set to limit the
amount of outgoing bandwidth that is being handled by the recorder.
3. Click Apply to save the settings and Exit to return to live view.
PPPoE settings
Although not usually used, you can connect the recorder directly to a DSL modem. To
do this, you need to select the PPPoE option in the network settings. Contact your ISP
to get the user name and password.
To configure PPPoE settings:
1. From the menu toolbar, click Network Settings > PPPoE.
2. Select the enable PPPoE checkbox.
3. Enter your user name and password, and confirm the password.
4. Click Apply and manually reboot the recorder to save the settings.