Chapter 13: Alarm and event setup
TruVision NVR 11 User Manual 115
Click Apply to save the settings. Click OK to return to the main window.
6. Click Apply to save the intrusion panel setup parameters.
7. Click Exit to return to live view.
TVRMobile push notifications
TVRMobile 3.0 (and higher) can receive events from the recorder.
The ‘Push notifications’ feature lets TVRMobile notify a user of new messages or
events even when the user is not actively using TVRMobile.
In TVRMobile, events can be received from the recorder and these events can be
shown as a push notification to the user.
The recorder needs to be connected to the internet to be able to use push notifications.
Even when the phone or tablet is used via Wi-Fi on the same LAN as the recorder, an
internet connection is required. The reason is that push notifications need to use the
Android or Apple Notification Center for sending the messages to the mobile
application.
Set up push notifications
To set up push notifications in the recorder
1. In the browser or OSD set up an event for the desired camera.
2. In the Actions tab, enable Notify Alarm Host.
3. Under Alarm & Event Setup > Alarm Host Setup leave the destination address
empty.
4. Go to Network Settings > Network Settings.
5. Enter the DNS, IPv4 Default Gateway settings. Also enter the HHTP port, RTSP
service port and Server port settings.
HTTP port (default: 80) (*)
RTSP port (default: 554) (*)
Server port (default: 8000)
(*) Some ISPs block the use of port 80 and/or 554. When these ports are blocked,
use a port number higher than 1024.
To set up push notifications for TVRMobile:
1. In TVRMobile, add the recorder.
2. In the main menu, tap Alarm and then tap Set Alarm Notification.
To Next Page
Loading...
Need help?
General
