66 TruVision NVR 11 User Manual
Chapter 10
Camera setup
Use the Camera Setup menu to configure IP cameras. You can also configure the
camera OSD, snapshots, recording settings, image quality, motion detection, privacy
masking, camera tampering, VCA settings, PTZ configurations, and V-stream settings.
Note: Not all settings are available for IP cameras. For advanced IP camera settings,
please consult the IP camera web browser interface.
Supported cameras
The recorder supports TruVision IP cameras up to 8 MPX as well as TVE encoders. It
also supports Gen 2 residential cameras. The recorder supports a wide range of third
party IP cameras through compliancy with the ONVIF standards for open camera
communication.
Note: UltraView cameras are not supported.
IP camera status
The IP Camera Status menu allows you to add, edit and remove IP cameras to the
recorder, as well as update the cameras’ firmware. The recorder supports all TruVision
IP cameras and encoders and is compliant with ONVIF profile S cameras.
Note: Ensure that the ONVIF camera has been tested together with the recorder before
installation.
To Next Page
Loading...
