ITech IT8200 Series Programming Guide

SYSTem Commands
Copyright © ITECH Electronic Co., Ltd. 10
as a storage disk, and when set as device type, it is used as a communication
interface.
Syntax
SYSTem:COMMunicate:USB:TYPE <CPD>
Arguments
DEVice|HOST
Defaults
HOST
Returns
DEVice|HOST
Example
SYST:COMM:USB:TYPE HOST
Query syntax
SYSTem:COMMunicate:USB:TYPE?
SYSTem:COMMunicate:SELect <CPD>
This command is used to set and query the communication method. This series
instrument comes standard with four communication interfaces: USB, LAN, VCP
and CAN, and supports two optional communication interfaces: GPIB, RS-232.
And the RS232 and GPIB options can be selected only after the communication
board corresponding to RS232 and GPIB is successfully inserted into the
corresponding position on the rear panel of the instrument.
Syntax
SYSTem:COMMunicate:SELect <CPD>
Arguments
TMC|VCP
Defaults
VCP
Returns
TMC|VCP
Example
SYST:COMM:SEL VCP //Set the USB communication interface to VCP
Query syntax
SYSTem:COMMunicate:SELect?

ITech IT8200 Series Specifications

General

Brand	ITech
Model	IT8200 Series
Category	Measuring Instruments
Language	English