ManagerIQEasy_UM_9752103002_GB_V3_1 112
6.27.2 Searching manually for Extension IQ Easy units.
The IQ Easy system will normally automatically look for newly connected Extension IQ Easy
units and add them to the system. The time interval for searching for newly connected
Extension IQ Easy units determines parameter “Rescan Ext.Box timer”.
Depending on the system load, a different value can be set here. If the value is set to “0 seconds”,
newly connected Extension IQ Easy units will not be automatically searched for. With system
adjustments this can be done manually (see Section 6.27.1).
The parameter can be adjusted as follows.
If necessary, go to the main screen (Home).
If necessary, log in as (User level, Expert), see Section 6.9.
Press (Info).
Browse using the and buttons to the page with the parameter “Rescan Ext.Box timer”
(You can also use the large non-visible areas to browse).
Click (EditMode) to change the parameter.
Press (Edit) after the “Rescan Ext.Box timer” parameter. A keyboard will now be opened.
Enter the desired scan time (value in seconds). Good values are, for example, 15, 30 or 60.
If the value is set to 0, the IQ Easy system will no longer automatically search for newly
connected Extension IQ Easy units.
Press (Home) to return to the main screen and log in again as a Basic user (see Section 6.9).
To Next Page
Loading...
Need help?
General