ManagerIQEasy_UM_9752103002_GB_V3_1 69
6.18 Linking and disconnecting Devices (Expert user)
The IQ Easy system has the option to connect bars and sensors. This allows them to exchange
measurement and control data with each other, so that a control loop can be built in order to
suppress static electricity in a controlled manner.
6.18.1 Linking a member with a Sensor Device (Expert user)
To link 2 or more Devices together, you must at least be logged in as an Expert user
(see Section 6.8).
If necessary, go to the main screen (Home).
If necessary, log in as (User level, Expert), see Section 6.9.
Press or (Device) of the Device to be connected.
If necessary, press (Information) to go to the Information screen.
Browse using the and buttons to the page with parameter “Paired sensor” (You can
also use the large non-visible areas to browse).
Click (EditMode) to change the parameter.
Press (Edit) after the “Paired sensor” parameter. A screen will open that looks like this.
To Next Page
Loading...