ManagerIQEasy_UM_9752103002_GB_V3_1 86
6.19 Activating and deactivating sensor segments (Expert user, Sensor version V5_2 only)
6.19.1 Activating and deactivating sensor segments via the settings screen (Expert user)
Up to 16 segments can be placed in a Sensor Device (version V5_2). Because in a Sensor
Device a Sensor Segment does not actually have to be placed at every position, positions
where no Sensor Segment has been placed can be switched off. Sensor Segments can also
be temporarily disabled. For this, the user must be logged in as an Expert (see Section 6.8).
If necessary, go to the main screen (Home).
If necessary, log in as (User level, Expert), see Section 6.9.
Press (Device) of the Device.
If necessary, press (Information) to go to the Information screen.
Browse using the and buttons to the page with the parameter “Active segments”
(You can also use the large non-visible areas to browse).
Click (EditMode) to change the parameter.
Press (Edit) after the “Active segments” parameter. A screen will open that looks like this.
Activate or deactivate the desired segments by pressing the corresponding segment button.
Press (Accept) to save the changes made.
Press (Home) to return to the main screen and log in again as a Basic user (see Section 6.9).
To Next Page
Loading...
Need help?
General