ManagerIQEasy_UM_9752103002_GB_V3_1 65
6.17.8 Users Standby/Run control level (Expert user)
The IQ Easy Manager has the option to block (Basic users) and/or (Advanced users)
from putting Devices in Standby/Running mode. The level of users who can put Devices in
Standby/Running mode is set as follows (the user must log in as an Expert user, see Section 6.8).
If necessary, go to the main screen (Home).
If necessary, log in as (User level, Expert), see Section 6.9.
Press (Info). The (Information) screen of the HMI will now open.
Browse using the and buttons to the page with the parameter “Standby/Run
access level” (You can also use the large non-visible areas to browse).
Click (EditMode) to change the parameter.
Press (Edit) after the “Standby/Run access level” parameter.
The following screen will be opened.
Select the desired user level that may have access to the Standby/Running Device buttons. The
screen will now close.
Press (Home) to return to the main screen and log in again as a Basic user (see Section 6.9).
To Next Page
Loading...