ManagerIQEasy_UM_9752103002_GB_V3_1 76
6.18.4 Disconnecting a coupled bar from the Sensor Device (Expert user)
To be able to disconnect linked Devices, you must at least become an Expert user (see Section 6.8).
If necessary, go to the main screen (Home).
If necessary, log in as (User level, Expert), see Section 6.9.
Press or (Device) of the Device to be paired.
If necessary, press (Information) to go to the Information screen.
Browse using the and buttons to the page with parameter “Paired sensor” (You can
also use the large non-visible areas to browse).
Click (EditMode) to change the parameter.
Press (Edit) after the “Paired sensor” parameter. A screen will open that looks like this.
Press “None”.
To Next Page
Loading...
Need help?
General