ManagerIQEasy_UM_9752103002_GB_V3_1 88
6.20 Enabling and disabling Sensor segments (Expert user)
6.20.1 Enabling and disabling Sensor segments via the settings screen (Expert user)
Up to 16 segments can be placed in a Sensor Device. Depending on, for example, the width of
the Web, Sensor Segments can be temporarily disabled. To enable and disable Sensor segments,
the user must be logged in as Expert (see Section 6.8).
If necessary, go to the main screen (Home).
If necessary, log in as (User level, Expert), see Section 6.9.
Press (Device) of the Device.
If necessary, press (Information) to go to the Information screen.
Browse using the and buttons to the page with the parameter “Enabled segments”
(You can also use the large non-visible areas to browse).
Click (EditMode) to change the parameter.
Press (Edit) after the “Enabled segments” parameter. A screen will open that looks like
this.
Enable or disable the desired segments by pressing the corresponding segment button.
Press (Accept) to save the changes made.
Press (Home) to return to the main screen and log in again as a Basic user (see Section 6.9).
To Next Page
Loading...
Need help?
General