ManagerIQEasy_UM_9752103002_GB_V3_1 74
6.18.3 Activating the CLFB voltage control (Expert user)
If the Sensor Devices and Bar Devices are linked to each other, the CLFB control can be
activated. For this, the user must be logged in as an Expert (see Section 6.8).
If necessary, go to the main screen (Home).
If necessary, log in as (User level, Expert), see Section 6.9.
Press or (Device) of the Device whose CFLB mode must be activated.
If necessary, press (Information) to go to the Information screen.
Browse using the and buttons to the page with parameter “Operation mode”
(You can also use the large non-visible areas to browse).
Click (EditMode) to change the parameter.
Press (Edit) after the “Operation mode” parameter. A screen will open that looks like this.
Now press “CLFB”.
To Next Page
Loading...
Need help?
General