ITW SIMCO ION Manager IQ Easy User Manual

ManagerIQEasy_UM_9752103002_GB_V3_1 68
6.17.11 Reading network IP address (Expert user)
To connect to the FTP server via a network, the user must know which IP address the Manager
IQ Easy has been assigned. This IP address can be read as follows. (The user must be logged
in as an Expert user, see Section 6.8)
If necessary, go to the main screen (Home).
If necessary, log in as (User level, Expert), see Section 6.9.
Press (Info). The (Information) screen of the HMI will now open.
Browse using the and buttons to the page with parameter “Ethernet IP address”
(You can also use the large non-visible areas to browse).
The IP address specified in this setting can be used in an FTP client to connect to the Manager
IQ Easy via the network (see Section 06:22).
Press (Home) to return to the main screen and log in again as a Basic user (see Section 6.9).

ITW SIMCO ION Manager IQ Easy Specifications

General

Brand	ITW
Model	SIMCO ION Manager IQ Easy
Category	Control Unit
Language	English