ManagerIQEasy_UM_9752103002_GB_V3_1 115
6.28.3 Removing the Disconnected Device from the IQ Easy system.
However, if a Device is disconnected from the system and will not be replaced, the Device can
be removed from the system so that the error status of the Device is removed.
If necessary, go to the main screen (Home).
If necessary, log in as (User level, Expert), see Section 6.9.
Press , , or (Device).
If necessary, press (Maintenance) to go to Maintenance screen.
Browse using the and buttons to the page with the Action “Disconnect Device”
(You can also use the large non-visible areas to browse).
The following screen will be opened:
Press “YES” if the Device will be replaced by another Device and the parameters of the current
Device must be transferred. The parameters of the current Device will now be saved on the
system (see Section 6.29.2).
Press “NO” if it is not desired to keep the parameters and settings of the current Device.
The screen will now close.
Press (Home) to return to the main screen and log in again as a Basic user (see Section 6.9).
To Next Page
Loading...