Jands Event Plus - To Record a Function Key; To Play Back a Function Key

112 Event V3 Manual
Advanced Features
17.10To Record a Function Key.
Press the Setup button to open the Setup Menu.
Move the cursor to the CTRL (Control) field.
Press the 1 (On) button to open the Set Control menu.
Move the cursor to the FKEYS (Function Keys) field.
Press the 1 (On) button to open the Set Function Keys menu.
Move the cursor to the ENABLE field.
Press Exit to close this menu (press Exit several times to close all menus).
Ensure that the Add/Solo Master switch is Off.
Press one of the Flash buttons on the right hand bank of Assign Masters. The
LED in the button will turn on.
Press the sequence of button presses to be recorded.
Press the Assign Master Flash button again. The LED in the button will turn
off.
17.20To Play Back a Function Key
1. Ensure that the Add/Solo Master switch is Off.
2. Press the same Assign Master Flash button as used to record the sequence.
3. The recorded sequence will be replayed.
Diagram 17A
1
2
3
4
5
6
7
8
9
10
11
☞