98 Event V3 Manual
Control Functions - Playback
14.20 Add / Solo Master Switch
The Flash buttons can be set to operate in three different ways or turned off
completely. To change the operation of the Flash buttons press the Add / Solo
switch. With each press of the button, the two LEDs within the switch change to
indicate which mode has been selected.
* Add: Indicated by the Green LED. Pressing a Flash button causes that output
to flash instantly to the level set by the Add/Solo Master fader.
* Add Latch: Indicated by the Green LED Flashing. The Flash buttons push-on
and push-off instead of flashing. When a Flash button is latched on, the channel
LED will flash synchronously with the Add / Solo switch LED. If
Add Latch is disabled while some channels are latched, the channels will unlatch
but will not become latched again if Add Latch is subsequently enabled.
* Solo: Indicated by the Red LED. Pressing a Flash button causes that output to
flash instantly to the level set by the Add/Solo Master fader, while at the same
time turning off all other desk output.
* Disabled: Indicated by neither LED being on. Pressing a channel Flash button
has NO effect.
14.30 DBO Switch
This button performs two functions:
* Blackout
When the button is pressed the entire output of the console is blacked out. The
button can be set to:
Momentary - the console is Blacked Out only while the DBO button is
depressed.
OR
Latching - the console is Blacked Out by pressing the DBO button. Output
is restored when the DBO button is pressed again.
* Inhibit
To prevent a channel from appearing in any output, hold a channel Flash button
down and press the DBO button.
14.51 To change the operation of the DBO switch from LTCH to MOMT:
1. Press the Setup button to open the Setup Menu.
2. Move the cursor to the CTRL (Controls) field and press the 1 (On) button
to open the Set Control menu.
3. Move the cursor to the DBO field and press the 1 (On) button to toggle
between MOMT (Momentary) and LTCH (Latching).
4. Press Exit to close this menu (press Exit several times to close all menus).
☞
Diagram 14B
1
Diagram 14B 2
☞
NOTE: When a channel is inhibited the LED in the associated Flash button flashes on and
off. However, if the console is set for Wide or Super Wide operation it is not
possible to inhibit the channels which do not have Flash buttons.
14B Add/Solo switch,
DBO switch.
▼
1
2
To Next Page
Loading...
Need help?
General
