Jands Event Plus - Adding Delay Time; Adding Delay Times to a Memory

80 Event V3 Manual
Managing Memories & Chases
12.40 Adding Delay Time
This function can be used to automate industrial shows by setting delay times for
all Memories used in the show.
Complex chase patterns can be created by setting delay times and using the Next
field to loop Memories (and Chases) back on themselves
12.41 Adding Delay Time to a Memory
Press the Memory button.
Enter the required Memory number (0-999) using the numeric keypad or
alternatively use the 1 (On)/2 (Off) button to change the displayed
Memory number.
Move the cursor to the MORE field, and keep moving the cursor to the
DELAY field after the MORE window of Chase opens.
Enter a Delay time of up to 99 minutes 59 seconds using the numeric keypad
or alternatively use the 1 (On)/2 (Off) button to change the existing value.
Press the Exit button to close the window and return to the standard window.
(To use the Assign Masters to control a Stack see Playback Section 13.00)
1
2
Diagram 12I
3
4
5
☞