68 Event V3 Manual
Managing Memories & Chases
11.00 Files
The previous section described how to assign Memories, Chases and Stacks to the
Assign faders. However, assigning items one at a time is slow and after you have
set up the faders for a particular song or part of the show you will want to save those
settings for easy recall later.
Files are just like Pages except that, while the makeup of a Page is factory set, a
File can contain any combination of Memories, Chases and Stacks.
The steps involved in saving and loading Files are described below.
11.10Saving a File
Ensure that the Assign Masters are loaded with Memories, Chases and Stacks as
you require.
Press the File button.
Use the keypad or 1 (On)/2 (Off) buttons to enter a File number (0 - 25).
Use the arrow buttons to move the cursor to the SAVE field.
Press the ON (+) button to save the file.
1
2
Diagram 11A + 11C
3
4
☞
11.20Loading a File
Press the File button.
Use the keypad or ON (+)/OFF (-) buttons to enter a File number (0 - 25).
Use the arrow buttons to move the cursor to the LOAD field.
Press the 1 (On) button.
The Assign Masters are loaded with the Memories, Chases and Stacks that were
previously saved in the File.
Diagram 11B
1
2
3
4
TIP: If Freeze is on, any Assign faders that were above zero% when the File was
changed will continue to control the old Memory / Chase until the faders are
returned to zero, at which time they will join the new File.
☞
To Next Page
Loading...
Need help?
General
