Jands Event Plus User Manual

Event V3 Manual 31
© Jands Electronics July 1995
7.30 Playing Back a Memory
To see what is recorded so far follow these steps:
1. Pull down all the Preset faders so you can see just what has been recorded
in the Memory.
2. Check that you can see the Memory number or the label you gave it in the
LCD window above one of the Assign Masters.
3. Move the Assign fader to 100%.
If you do not see anything, check that the Grand Master is at full. If you can not see
what you expected try recording again, paying careful attention to the procedures.
(For more information on Play Back see Section 13.00).

Jands Event Plus Specifications

General

Brand	Jands
Model	Event Plus
Category	Lighting Equipment
Language	English