118 Event V3 Manual
Advanced Features
18.30 Setting Channels to Ignore Flash Button Solo Operation
Pressing A Flash button when in Solo mode will cause all other console channels
to “black out”. This can cause unwanted effects on channels controlling moving
lights or colour changers.
To set channels to ignore Solo:
Press the Setup button to open the Setup menu.
Move the cursor to the UTIL (Utilities) field.
Press the 1 (On) button to open the Set Utilities menu.
Move the cursor to the SOLO field.
Press the 1 (On) button to open the Setup Channel Solo menu.
Move the cursor to the CHAN# (Channel) field.
Set a channel number.
Move the cursor to the THRU (Through) field.
Set an end channel number.
Move the cursor to the SAFETY field.
Set it to ON.
Repeat steps from to for any other channels or groups of channels.
Press Exit to close this menu (press Exit twice to return to the standard
screen).
1
2
3
4
5
6
7
8
9
Note: If you just want to set one channel, leave this field as same as the CHAN# field.
10
11
12
13
11
2
Diagram 18C
☞
To Next Page
Loading...
Need help?
General
