Jands Event Plus - Edit File; Changing the Default File Settings; Restoring the Factory Setting for File

© Jands Electronics May 1995
Event V3 Manual 109
15.60 Edit File
15.61 Changing the Default File Settings
It is possible to change the way Files work using the Edit File menu.
However, this is an advanced feature and will probably not be required by most
users. The Edit File menu is used to limit the number of Assign Masters that will
be loaded when a new File is loaded.
Note: When a File is saved ALL the settings of the Assign Masters are saved. Edit File
is only used to limit the number of Assign faders that are updated by loading a
File.
1. Press the Edit button then press the File button.
2. With the cursor in the FIRST field, set the Assign Master fader number
which will be the first of a group to be loaded with the contents of a File.
3. Move the cursor to the LAST field, set the Assign Master fader number
which will be the last of a group to be loaded with the contents of a File.
4. Press the Exit key
Example:
The operator might want to use the first six memories stored in a file.
However, when this file is loaded to the Assign Masters, the remaining 18
Assign Masters are not to be changed. Set the FIRST field to 1 and the LAST
field to 6.
15.62 Restoring The Factory Settings for File
To restore the default settings for Edit File:
1. Press the Edit button then press the File button.
2. Move the cursor to the RESTORE field.
3. Press the 1 (On) button.
4. Press the Exit key.