136 Event V3 Manual
Advanced Features
23.00 Resetting the Console
Reset is used to reset the console and optionally clear all data including Memories,
Chases, Patches and the Password. Reset can be used to quickly erase all data that
has been recorded in an Event.
NOTE: It is recommemded that a Deep Clear be performed each time a new show is to
be recorded.
Diagram 23A
1
2
4
3
5
6
7
☞
23.10 To Reset the Console
Turn power switch off first before resetting the console, then follow the steps
below to reset the console:
Hold the DBO, ADD/SOLO MASTER and HOLD buttons down while
turning power on to the console.
The menu illustrated in diagram 23A appears on the right hand side LCD
window.
Move the cursor to the CONSOLE field.
Press the 1 (On) button.
Press the RECORD button to confirm the console Reset.
If required, enter a Password (up to 6 characters) using the flash buttons.
If no Password is required press Exit. All data is now cleared from the
console and all settings revert to the factory set defaults.
To Next Page
Loading...
Need help?
General
