Jands Event Plus User Manual

30 Event V3 Manual
Creating Memories & Chases
7.20 Labelling a Memory
Memories can be labelled to allow easy identification of their contents. For
example, Memories might be labelled BLUE WASH or DRUM SOLO; whenever
these Memories are loaded to the Assign Masters their labels are displayed in the
LCD window above the Assign fader.
1. Press the Memory button.
2. Enter the Memory number (0 - 999) to be labelled using the numeric keypad
or alternatively use the 1 (On)/2 (Off) buttons to change the displayed
Memory number.
3. Use the arrow buttons to move the cursor to the Label field (to the right of
the Memory number field).
4. Type a label of up to eight characters using the Flash buttons.
NOTE: The cursor automatically moves to the Label field if a 3 digit number is entered.
5. Press the Exit button if no more Memories are to be labelled.
6. Do NOT press the Record button if you are only entering or changing a
label.
NOTE: Each Flash button is marked on the front panel with a character (1=A, 2=B etc.).
Typing a label will NOT cause lights to flash on at the same time.
Diagram 7C + 7B
TIP: Memories can be labelled while they are being recorded (using the menu
method) or labelled later by using the Memory menu.
_
0
__
1
_
M
789
456
123
0
MEMORY EDIT CHASE
PAGE ASSIGN FILE
BUILD CLEAR STACK
EXIT SETUP RECORD
OR
OR
EXIT
1
2
0
BUILD CLEAR
SETUP RECORD
4
5
PAGE ASSIGN
7
MEMORY
8
EDIT
3
STACK
6
FILE
9
CHASE
Press Exit
if only
entering
a label
x
x
x
x
x
x
x
x
A1
PRESETPRESET
FLASHFLASH
PRESET
FLASH
ASSIGNASSIGN
FLASHFLASH
ASSIGN
FLASH
7C Labelling a Memory
▼
☞

Jands Event Plus Specifications

General

Brand	Jands
Model	Event Plus
Category	Lighting Equipment
Language	English