122 Event V3 Manual
Advanced Features
19.20 Changing the Increment Between Memories When
Recording
Normally when a Memory is recorded the Memory menu automatically advances
to the next Memory number, allowing a number of Memories to be quickly
recorded.
However it can be useful to change the increment between Memories when the
menu advances.
1. Press the Setup button to open the Setup menu.
2. Move the cursor to the PREF (Preferences) field and press the 1 (On) button
to open the Set Preferences menu.
3. Move the cursor to the Incr (Increment) field and set an Increment between
1 and 10.
4. Press Exit to close this menu (press Exit several times to close all menus).
Example:
Normally when Memories are recorded (using the Memory menu) the
Memory number automatically advances by 1 after the Record button is
pressed. However, in first plotting a show which is to be run using the
crossfade controls, you might want to leave a number of free Memories
between each Memory being recorded, to make it easier to insert extra cues
at a later time.
TIP: If the increment was set to 10 and the first Memory recorded was M 10 the
Memory menu would advance to M 20.
The Memory number can still be set to any intermediate value by typing the
required number from the keypad.
19.30 Turning the Help Screen On and Off
The help screen which displays on the LCD to the left of the menu LCD can be
turned off when the user becomes more familiar with the console.
1. Press the Setup button to open the Setup menu.
2. Move the cursor to the Pref (Preferences) field and press the 1 (On) button
to open the Set Pref menu.
3. Move the cursor to the Help field and press the 2 (Off) button to turn Help
off, or press the 1 (On) button to turn Help back on.
4. Press Exit to close this menu (press Exit several times to close all menus).
To Next Page
Loading...
Need help?
General
