72 Event V3 Manual
Managing Memories & Chases
12.13 Delay field
This field sets the time between the start of this Memory or Chase and the start of
the Infade of the Memory or Chase set in the NEXT field, i.e. if set to 0:10.5 the
next Memory or Chase will begin to fade in 10.5 seconds after this Memory started
to fade in.
12.20Changing the NEXT Field
The NEXT field is used to determine the playback order of Memories and Chases
in a crossfade Stack. This facility can also be used to insert a Chase or Memory into
a Stack sequence.
12.21 Changing the NEXT Field - Memory
Press the Memory button.
Enter the required Memory (0 - 999) using the numeric keypad or
alternatively use the 1 (On)/2 (Off) buttons to change the displayed
Memory number.
Move the cursor to the MORE field and keep moving the cursor to the NEXT
field after the MORE window is opened.
Enter the number of the Memory which is to follow this Memory.
Press the Exit button, if no more Memories are to be set.
1
2
Diagram 12E
☞
NOTE: In the Memory menu the Infade and Outfade fields can be seen when the menu is
opened and the NEXT field is revealed by moving the cursor to the extreme right hand
side of the menu.
In the Chase menu the Infade, Outfade and NEXT fields are revealed by moving the
cursor to the extreme right hand side of the menu (to where it shows MORE).
em
1
ex
1
N
M
M
M
E
:
Y
.
A
0
L
0
D
00
:
0
t
1
12D Delay field
▼
3
5
4
Diagram 12D
TIP: If in the Memory menu you want to change the setting from a Memory number
to a Chase, use the left arrow button to move the cursor over the M and then press
the 1 (On) button to change the M to a C, (this can also be achieved by pressing
the Flash button marked C).
NOTE: Do NOT press the Record button if only entering or changing the NEXT field.
☞
To Next Page
Loading...
Need help?
General
