Section 19 Maintenance & Inspection 19-56
6 Click on the [Start] button.
A confirmation dialog is displayed.
7 Click on the [OK] button.
Restoration of data from the drive that was selected from the drive selection combo box to the
hard disk of this equipment starts.
If data already exists in the hard disk, an overwriting confirmation dialog is displayed.
To start restoration, click the [OK] button.
Note
• Do not perform any operation until restoration is completed. If some operation is
performed, restoration may fail.
• If backup is executed while enough free space is not available in the USB memory, the
“Error” message is displayed. Secure enough free space before executing backup. For
the size of the data to be backed up, check the “Usage” column in the “File Information”
list in “17.4.2 Managing storage”. (For instance, when the AVCS chart for the entire world
is installed, the size will be about 11GB.)
Memo
If the data to be restored is incompatible with this equipment, the following dialog is
displayed and data is not restored.
Cancel the task by clicking on the [OK] button.
To Next Page
Loading...
