7 – 52
7.5
7
7.5.6.8 Restoring User Memory
This function is used to read the contents written in the internal memory. After reading, the system assumes
the transmission standby status.
Procedures
1. Follow procedures 1 to 3 in subsection 7.5.6.1 to open the MAINTENANCE
MENU.
2. Press the
9
key to select "RESTORE USER SETTING".
3. Press the
9
key to set the system in the user memory restoring
standby mode.
4. Press the
ENT
key to restore or the
CLR
key not to restore according
to the direction on the screen.
After restoration, the system assumes the transmission standby mode.
Exit
5. Press the
SUB
MENU
key.
Maintenance Menu
MAINTENANCE MENU
Press an item number key.
0. PREVIOUS MENU
1. ANTENNA HEIGHT UP to 5m
5–10m 10–20m MORE 20m
2. SERIAL INPUT DEVICE
2AXIS LOG HDG SENSOR RS232C
3. ANTENNA SWITCH
TRANSFER DISCARD
4. PARTIAL MASTER RESET
5. ALL MASTER RESET
6. INTERNAL SETTING to CARD 2
7. CARD 2 to INTERNAL SETTING
8. MEMOLIZE USER SETTING
9. RESTORE USER SETTING
To close this menu, Press (SUB MENU) key.
To Next Page
Loading...
Need help?
General
