JRC JMA-3910-4 User Manual

7 – 50
7.5
7
7.5.6.5 Internal Setting to Card 2
This function is used to write the contents internally set into card 2. Use this function after inserting a
memory card for writing to the lower side of the card slot.
Procedures
1. Follow procedures 1 to 3 in subsection 7.5.6.1 to open the MAINTENANCE
MENU.
2. Press the
6
key to select "INTERNAL SETTING to CARD 2".
3. Press the
6
key to set the system in the standby mode.
4. Press the
ENT
key to write or the
CLR
key not to write according to
the direction on the screen.
After writing, a message informing the completion of writing appears.
Exit
5. Press the
SUB
MENU
key.
Maintenance Menu
MAINTENANCE MENU
Press an item number key.
0. PREVIOUS MENU
1. ANTENNA HEIGHT UP to 5m
5–10m 10–20m MORE 20m
2. SERIAL INPUT DEVICE
2AXIS LOG HDG SENSOR RS232C
3. ANTENNA SWITCH
TRANSFER DISCARD
4. PARTIAL MASTER RESET
5. ALL MASTER RESET
6. INTERNAL SETTING to CARD 2
7. CARD 2 to INTERNAL SETTING
8. MEMOLIZE USER SETTING
9. RESTORE USER SETTING
To close this menu, Press (SUB MENU) key.

JRC JMA-3910-4 Specifications

General

Brand	JRC
Model	JMA-3910-4
Category	Marine Radar
Language	English