3-5 Section 3 Operations on the Chart Screen
3.2.3 Operation via [Dropped EBL/VRM] -
[Make VRM1] or [Make VRM2]
Operations are common in VRM1 and VRM2. The following description is based on VRM1.
1 Right-click on the chart to display the context menu.
2 Select [Dropped EBL/VRM] - [Make VRM1] from the context menu.
VRM1 is displayed and the measurement base point is displayed on the cursor.
3 Move the cursor to any position and click.
The measurement base point will be fixed.
4 Move the cursor to adjust the distance and click at any position.
The VRM1 distance will be fixed.
3.2.4 Operation via [Dropped EBL/VRM] -
[Move base point of EBL1/VRM1] or
[Move base point of EBL2/VRM2]
Operations are common in [Move base point of EBL1/VRM1] and [Move base point of EBL2/VRM2].
The following description is based on [Move base point of EBL1/VRM1].
1 Right-click on the chart to display the context menu.
2 Select [Dropped EBL/VRM] - [Move base point of EBL1/VRM1] from the context menu.
EBL1 and VRM1 are displayed and the measurement base point is displayed on the cursor.
3 Move the cursor to any position and click.
The EBL/VRM measurement base point will be fixed.
3.2.5 Operation via [CCRP EBL/VRM] -
[Make EBL1/VRM1] or [Make EBL2/ VRM2]
Operations are common in EBL1/VRM1 and EBL2/VRM2. The following description is based on
EBL1/VRM1.
1 Right-click on the chart to display the context menu.
2 Select [CCRP EBL/VRM] - [Make EBL1/VRM1] from the context menu.
EBL1 and VRM1 are displayed and the measurement base point is displayed on the ship.
3 Move the cursor to any position and click.
The ELB1 direction and VRM1 distance will be fixed.
To Next Page
Loading...
Need help?
General
