Section 5 Route monitoring 5-8
5.4 Reversing the Route
The direction of the route being monitored can be reversed.
When it is reversed, the WPT next to the start point after the reversal becomes new To WPT.
The reversed state is retained even after the power supply is turned off.
The reversed state is cancelled when another route monitoring is started.
Use the following operation to open the [Route/Destination] dialogue.
[Menu] button → Route Planning → Set Route/Destination
1 Click on (Reverse button).
The route being monitored is reversed.
Memo
The reverse button is disabled if no route is being monitored.
To Next Page
Loading...
