JRC JMR-5400 Series - Displaying the [CURS INFO] Dialogue

Section 3 Operations on the Chart Screen 3-8
3.4 Displaying the [CURS INFO] Dialogue
Move the cursor in the chart to change it to the cross-hair cursor. The [CURS INFO] dialogue displays
information of the cursor position.
Procedure
Use the following operation to display the [CURS INFO] dialogue.
[Menu] button → Tools → Cursor Readout
Memo
The [CURS INFO] dialogue is open when the plotter mode is activated or when the system restarts
in plotter mode.
(1) Base point setting button
The base point for the cursor direction/distance display can be set to any point.
For details, see
3.4.1 Setting the base point for CURS INFO.
(2) TTG and ETA display
Displays TTG (total time to go) and ETA (estimated time of arrival) from the ship to the cursor point.
(3) Latitude and longitude of the cursor point
Displays the latitude and longitude of the cursor point.
(4) Cursor direction display
Displays the direction from the ship or any base point to the cursor point.
(5) Cursor distance display
Displays the distance from the ship or any base point to the cursor point.
(1)
(2)
(3)
(4)
(5)
(6)
(7)