5-5 Section 5 Route monitoring
5.2.2 Configuring [Settings] - [Route] from the
menu
Procedure
Use the following operation to display the [Route] dialogue in the Edit pane of the [Settings] dialogue.
[Menu] button → Settings → Route
The following table lists the setting items of the [Route] dialogue.
[Route Mode]
combo box
Select a route type.
Plotter: Uses the destination route.
NMEA: Uses the NMEA destination display feature.
When [NMEA] is selected, all the other setting items
of this dialogue are disabled.
Plotter / NMEA
[WPT Switching
Mode] combo box
Set whether To WPT is switched automatically or
manually.
AUTO: To WPT is switched automatically.
Manual: To WPT is switched manually.
With [AUTO] selected, when the ship enters the
arrival circle of the To WPT, the next WPT will be the
To W PT. [AUTO] works only if [Alert Type] is set to
[Arrival] in the [Alert] menu (see 6.3.1 Configuring the
alerts for the destination route).
AUTO / Manual
[Save Temporary
Route] check box
When it is checked, the temporal/GoTo route is saved
even after the power supply is turned off.
Enabled: Checked
Disabled: Unchecked
To Next Page
Loading...
Need help?
General
