JRC JMR-5400 Series - Page 80

Section 4 Route Planning 4-12
4.5.1.1 Adding a new proposed destination
Open the [Destination List] dialogue and operate it as follows.
1 On a proposed destination row where the latitude and longitude are not determined,
click on the [LAT] field.
2 Enter the latitude using the software keyboard.
When the latitude is entered, the longitude can be entered.
3 Enter the longitude using the software keyboard.
When the input latitude and longitude are valid, the position is registered as a proposed
destination.
4 Click on the [] button to close the [Destination List] dialogue.
4.5.1.2 Changing the position of a proposed destination
Open the [Destination List] dialogue and operate it as follows.
1 On a proposed destination row for which you want to change the position, click on the
[LAT] field.
2 Enter the latitude using the software keyboard.
When the latitude is entered, the longitude can be entered.
3 Enter the longitude using the software keyboard.
When the input latitude and longitude are valid, this new position is set for the destination.
4 Click on the [] button to close the [Destination List] dialogue.
4.5.1.3 Editing the comment of a proposed destination
Open the [Destination List] dialogue and operate it as follows.
1 On a proposed destination row to which you want to add/edit a comment, click on the
[Comment] field.
2 Enter a comment.
Up to 32 characters can be entered.
3 Click on the [] button to close the [Destination List] dialogue.
4.5.1.4 Moving to a proposed destination
Open the [Destination List] dialogue and operate it as follows.
1 Click on the number for the destination to move to.
2 Click on the [Jump] button.
The selected proposed destination is displayed in the centre of the chart.
3 Click on the [] button to close the [Destination List] dialogue.