JRC JMR-5410-6X - Radar Signal Information

Section 2 Name and Function of Each Unit 2-14
2.2.11 Radar signal information
[Echo Process] combo box
This setting is enabled to set a video processing
function from the list
For the details, refer to "5.4.4 Using video processing
(Echo Process)".
[×2] (Double scale display) button When this button
is clicked on, the double scale zoom function is
switched to On/Off.
For the details, refer to "5.4.10 Doubling the size of
radar image".
[IR] combo box
This setting is enabled to set a radar interference rejection
function from the list
For the details, refer to "5.4.1 Interference Rejection (IR
Function)".
[Chirp Channel] button
This button sets the Chirp Channel function to On/Off.
*The Chirp Channel function can be set only when a
small solid -state radar antenna is connected. By
changing the transmission central frequency
(channel) of Q0N (Chirp wave: Frequency modulation
pulse) that is used for pulse compression,
interferences can be controlled.
[1] Reception sensitivity adjustment
The reception sensitivity can be adjusted.
For the details, refer to "5.3.4 Adjusting
gain".
[2] Sea clutter adjustment
The sea clutter rejection level can be
adjusted.
For the details, refer to "5.3.5 Rejecting
sea clutter (Sea)".
[3] Rain and snow clutter adjustment
The rain and snow clutter rejection level
can be adjusted.
For the details, refer to "5.3.6 Rejecting
rain/snow clutter".
[1]
[2]
[3]
[Target Enhance] combo box
This setting is enabled to set a target enhancement
function from the list
For the details, refer to
"5.4.3 Enhancing targets".