JRC JMR-5410-6X - Setting and Operating AIS; Enabling AIS Function; Activating AIS Targets (Activate AIS); Manual Activation

6-31 Section 6 Target Tracking and AIS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
6.6 Setting and operating AIS
6.6.1 Enabling AIS function
Memo
• When the AIS function is set to Off, the AIS display function is turned off and AIS symbols are
no longer displayed.
• Once AIS function is set to Off, even If a dangerous target exists, the function
is not
automatically switched to On.
1 Click on the [AIS] button for other ship information on the upper right of PPI.
The button indication becomes ON and the AIS function becomes enabled.
ON indication:
The received AIS information is displayed on the screen.
6.6.2 Activating AIS targets (Activate AIS)
Activates an AIS target, and displays the target's vector and make a collision decision.
6.6.2.1 Manual activation
Activates an AIS target in manual mode to display the vector and heading line.
1 Set the cursor mode to the AUTO mode.
2 Place the cursor on the sleeping AIS symbol to be activated and then click on.
The selected AIS target is activated.