JRC JMR-5410-6X - Measuring between Arbitrary Two Points

4-11 Section 4 Range and Bearing Measurement Methods
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
To clear the VRM:
1 Press the [VRM] dial.
The context menu is displayed.
2 By turning the dial, select either [VRM1 Hide] or [VRM2 Hide].
3 Press the [VRM] dial.
If [VRM1 Hide] is being selected, the selection of VRM1 is cleared.
If [VRM2 Hide] is being selected, the selection of VRM2 is cleared.
4.5.2 Measuring between arbitrary two points
The range and bearing between arbitrary two points can be measured as follows.
Here, the manipulation with EBL2/VRM2 is explained. The same operation can be performed with
EBL1/VRM1.
Memo
To manipulate the EBL/VRM, the RADAR transmission status must be “Transmit”.
EBL2
Cape
VRM2
CCRP
Cape