JRC JMR-5410-6X - Alarm for New Target Acquired in Automatic Acquisition Guard Zone (New Target)

6-41 Section 6 Target Tracking and AIS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
6.7.2 Alarm for new target acquired in automatic
acquisition guard zone (New target)
In setting an automatic acquisition guard zone, it is necessary to adjust the gain, sea
clutter suppression and rain/snow clutter suppression to ensure that target echoes
are displayed in the optimum conditions.
No automatic acquisition guard zone alarms will be issued for targets undetected by
the radar, and this may cause accidents such as collisions.
The automatic acquisition function sets a zone in a range and issues an alarm when a new target
(which is not yet acquired) goes into this zone.
For the setting of an automatic acquisition guard zone, refer to "6.5.1 Acquiring target".
Alarm for New Target Acquired in Automatic Acquisition Guard Zone
Status
Symbol on
display
Alert
characters
Alarm sound Conditions
New target in
automatic
acquisition
guard zone
Red Blinking
New
Target
Beep sound
(beep-beep-beep)
Alarm
acknowledgeable
The alarm is issued when a
new target is acquired in the
automatic acquisition guard
zone.
Memo
When an already acquired target goes into automatic acquisition guard zone, the alarm for the
new target acquired in automatic acquisition guard zone does not sound.
12