JRC JMR-5410-6X - Setting the EBL Bearing to True;Relative Display; Setting up the Measurement Starting Points

3-23 Section 3 Common Basic Operations
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
3.13.3.2 Setting up the measurement starting points
The measurement starting points of the EBL/VRM in operation can be changed. Set up the
measurement starting points as usage.
1 Enable the manipulation of EBL/VRM by clicking on the EBL/VRM button.
The display of the clicked button changes from [Off] to the bearing presentation of the
measurement starting point.
2 Click on the Measurement Starting Point button of the EBL/VRM in the operational
state.
Each time this button is clicked on, the measurement starting point switches in the order of blank
field → [C] → [D] → blank field and so on.
Blank field (CCRP): Sets the measurement starting point to the own ship position (CCRP).
C (Carried): Fixes the measurement starting point on the screen.
D (Dropped): Fixes the measurement starting point at longitude and latitude point.
Memo
In the case of [D], it is necessary to connect a navigation unit.
3.13.3.3 Setting the EBL bearing to True/Relative display
The EBL bearing True/Relative display can be changed by using the True/Relative button of EBL of the
Navigation Tool (measuring tools).
Setting the EBL numeric value display mode
1 Click on the true/relative button of EBL bearing.
Each time the button is clicked on, display switches between [T] → [R] → [T] in this order.
[T]: Displays EBL bearing in true bearing.
[R]: Displays EBL bearing in relative bearing.
Memo
The true/relative presentation of EBL bearing is common between EBL1 and EBL2.
Measurement starting point button
True/relative button of EBL bearing