JRC JMR-5410-6X - Displaying;Resetting the Current Voyage Distance; Setting and Confirming the Sensor Source; Setting the Sensor Source

15-5 Section 15 Maintenance & Inspection
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
23
24
24
26
27
15.1.5 Displaying/resetting the current voyage distance
This equipment displays the current voyage distance (estimated voyage distance) that is calculated
from the speed over the ground and the speed through the water.
The voyage distance can also be reset.
Memo
While the ship is anchored or sailing at low speed, it takes up to around 2 minutes to reset the
current voyage distance.
[Operation procedure]
Open the voyage distance display screen by performing the following menu operations.
[Menu] button → Maintenance → Voyage Distance
The following table shows the items that are displayed.
Item Displayed information
Current Voyage Distance
Displays the current voyage distance.
Ground Displays the current voyage distance that was calculated
from the
speed over the ground.
Water Displays the current voyage distance that was calculated
from the
speed through the water.
Clear Resets the accumulated voyage distance. When this button is clicked
on, a confirmation dialogue is displayed. To reset the voyage distance,
click on the [Yes] button, to not reset the voyage distance, click on the
[No] button.
15.1.6 Setting and confirming the sensor source
Set and confirm the sensor source.
15.1.6.1 Setting the sensor source
Select a sensor source.
[Operation procedure]
Open the sensor source setting screen by performing the following menu operations.
[Menu] button → Maintenance → Sensor Selection/Status → Sensor Selection
The table below shows the setting items.
Memo
Some sources may not be selected depending on the configuration.
Setting item Setting contents Setting value
Position Selects a sensor source of the position information from the
combo box.
GPS1 / GPS2 /
GPS3 / GPS4
Heading Selects a heading sensor source from the combo box.
When [MAN] is set for the sensor source, a ship’s heading
value can be input in the [Heading] input box.
Ship’s heading value input range: 0.0-359.9°
MAN / Gyro1 /
Gyro2 / G/C 1 /
G/C 2 / MAG1 /
MAG2