JRC JMR-5410-6X - Creating an Object with EBL;VRM Operation

10-19 Section 10 Creating a User Map
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
10.6.2.2 Creating an object with EBL/VRM operation
1 Click on the [EBL/VRM] button on the drawing toolbar.
The cursor changes to the EBL/VRM reference point cursor. (Refer to "10.5.5 Creating an
object in the EBL/VRM mode").
2 Click on the position of the reference point of the EBL/VRM marker.
The EBL/VRM marker is displayed.
3 Place the EBL/VRM marker on the starting point and click the button.
A vertex is created on the position on which the button was clicked and the information is
reflected in the object property dialogue. (Refer to "10.5.8 Object property dialogue").
4 Click on the position of the reference point.
The EBL/VRM marker that determines the 2
nd
point is displayed.
5 Place the EBL/VRM marker on the 2
nd
vertex and click the button.
A vertex is created on the position on which the button was clicked and the information is
reflected in the object property dialogue. (Refer to "10.5.8 Object property dialogue").
The EBL/VRM marker is reset to the EBL/VRM reference point cursor.
6 Adjust the parameters on the object property dialogue.
7 To create an object on another position continuously, repeat Steps 2 to 6.
2
nd
vertex
Starting point