JRC JMR-5410-6X - TT Simulator] (Target Tracking Simulator)

6-29 Section 6 Target Tracking and AIS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
6.5.8.2 [TT Simulator] (Target tracking simulator)
Pseudo-targets are generated in certain known positions to check whether the target tracking units are
operating normally. Since the pseudo-targets move depending on known parameters, the values for
these pseudo-targets can be compared with the known value if the pseudo-targets are acquired and
tracked, and displayed. Thus, it can be checked if the system is operating normally.
1 Click on the Standby/Transmit selector button for Radar system information to place
the radar in the standby state.
The button indication changes to [Standby].
2 Select simulator scenario from the [TT Simulator] combo box.
List of target tracking simulator/scenario
Scenario Target No.
Motion
(true motion)
Moving start point
Speed [kn]
Course [
o
]
Range [NM]
Bearing [
o
]
Off
-
-
-
-
-
Scenario1
1
28.3
45
9.5
270
2
22.4
27
1.12
333
3
15.3
293
9.25
45
Scenario 2
1
30
135
8
23
2
20
270
5
135
Scenario 3
1
45
180
5
23
2
0
-
3
340
3
30
0
8
180
Scenario 4
1
0
0
2.02
31
2
70
225
7.01
37
Scenario 5
1
20
45
4.47
288
2
30
45
5.1
304
3
40
45
6.71
288
4
0
-
7.07
307
5
60
200
12
352
6
20
225
11
315
7
40
190
14.4
349
8
-
-
8
318
9
-
-
9
318
10
-
-
10
318
Scenario 6
1
5
96
5
0
2
105
225
6
45
Memo
When the simulator is operating, set 0
°
as the heading bearing
3 Click on the Standby/Transmit selector button to place the radar in the transmission
state.
The button indication changes to [Transmit]. The simulator turns on, the pseudo-target is
generated, and the letter "X" appears on the lower side of the radar screen and near the
pseudo-target to indicate that simulation mode is being executed.