JRC JMR-5410-6X - Creating an Object with EBL;VRM Operation

Section 10 Creating a User Map 10-16
10.6.1.2 Creating an object with EBL/VRM operation
1
Click on the [EBL/VRM] button on the drawing toolbar.
The cursor changes to the EBL/VRM reference point cursor. (Refer to "10.5.5 Creating an
object in the EBL/VRM mode").
2 Click on the position of the reference point of the EBL/VRM marker.
The EBL/VRM marker is displayed.
3 Place the EBL/VRM marker on the position on which the object is to be created and
click the button.
An object is created on the position on which the button was clicked and the property
information is reflected in the object property dialogue. (Refer to "10.5.8 Object property
dialogue").
4 Adjust the parameters on the object property dialogue.
5 To create an object on another position continuously, repeat Steps 2 to 4.