JRC JMR-5410-6X - Setting up the Display of Unit of Setting Value; Setting Control of the Top Screen and Menus

11-17 Section 11 Setting up Screen View
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
11.1.12 Setting up the display of unit of setting value
Memo
Some items may not be displayed depending on the installation setting.
Set a unit to be displayed for each setting value.
[Operation procedure]
Open the setting screen of unit display by the following menu operations.
[Menu] button → View → Unit
The descriptions of settings are shown in the table below.
Setting Item Description of Setting Setting Value
Depth
Select a unit of the water depth from the combo box.
m / ft / fm
Depth
(C-MAP MAX)
Select a water depth display unit on the chart from the
combo box.
ft / fm / m /decimal fm
Current Speed
Select a unit of the current speed from the combo box.
kn / m/s / km/h
Wind Speed
Select a unit of the wind speed from the combo box.
kn / m/s / km/h
Air TEMP
Select a unit of the air temperature from the combo box.
°C / °F
Water TEMP
Select a unit of the water temperature from the combo box.
°C / °F
Air Pressure
Select a unit of the air pressure from the combo box.
hPa / mbar
Wind Direction
(True)
Select a wind direction (true) display method from the
combo box.
16 directions /
Degree
11.1.13 Setting control of the top screen and menus
When you select [Control] in the classification pane, the [Control] dialogue is displayed in the edit pane.
[Operation procedure]
Open the top screen control setting screen by performing the following menu operations.
[Menu] button → View → Control
Top screen information [Page 1]
Set control of the information that is displayed on the top screen.
Setting Item Description of Setting Setting Value
Show Own Track
Control
Selecting this enables to display own track
control.
To enable: Select.
To disable: Clear.
Display Key Operation
Number
Display/hide the badge on the target component
by menu operations on numeric keys.
Shown: Selected
Hidden: Clear
Menu Display [Page 2]
Set each menu to be displayed or hidden.
This function enables the hiding of menus of low use frequency freely.
1 Set the check box of the target menu to On/Off.
On (selected): Displays on the menu.
Off (cleared): Hides from the menu.
For [View] and [View] – [Control] (this menu) are constantly set to On and cannot be hidden.