JRC JMR-5410-6X - RADAR Alarm Issuing Conditions

12-5 Section 12 Setting up Alerts
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
12.5 RADAR Alarm Issuing Conditions
[Operation procedure]
Open the RADAR Alarm issuing condition setting screen by performing the following menu operations.
[Menu] button → Alert → RADAR Alarm
In this dialogue, set a RADAR Alarm issuing range.
The following table shows the setting items.
Setting item
Description of setting
Setting value
RADAR Alarm Mode Set a condition for issuing an alarm.
In: A “RADAR Alarm (In)” alarm is issued while a
target (echo) exists within the alarm range.
Out: A “RADAR Alarm (Out)” is issued while a
target (echo) exists outside of the alarm range.
In / Out
Detection Level Set a signal level of the radar echo that is
recognised as a target.
1 (Low) / 2 / 3 / 4 (High)
[Sector] tab
Set a Sector alarm issuing range.
Setting item
Description of setting
Setting value
1/2 tab A sector to be set can be selected from Sector 1 or
Sector 2.
1 / 2
Use Sector 1 / Use
Sector 2
Set a sector alert to On/Off. When this item is set
to Off, the Sector is hidden.
On: Select
Off: Clear
Make Sector 1 / Make
Sector 2
The cursor mode is set to a sector creation mode.
When the [Make Sector] button is pressed and the
[Use Sector 1 / Use Sector 2] check box is Off, the
item is set to On automatically.
-
Start Angle
Set a sector start angle.
000.0° to 359.9°
End Angle
Set a sector end angle.
000.0
°
to 359.9
°
Start Distance
Set a sector start distance.
1.0 NM to 31.5 NM
End Distance Set a sector end distance.
A sector end distance can be set under the
conditions where the distance width from the start
distance is within the range from 0.50 NM to 2.00
NM.
1.5 NM to 32.0 NM